Important keys, Led indicator, Create master code groups to add users – SDC E72K-A CIVIC SERIES 160 User Electronic Digital Door Lock User Manual
Page 2
P:\INSTALLATION INST\ELECTRIFIED LOCKSETS/INST-E72K-A/INST-E72K-A.vsd REV -
07-08 Page 2
PROGRAMMING KEY (#)
This code is required to perform all programming functions. The number of digits used for the User ID and PIN of each additional
user must be the same as the Master Code.
User ID and PIN followed by ( ) will open the lock.
*
*
ALL USERS MUST BE ASSIGNED TO A GROUP. Users in the same group will have the same access rights.
Each group is assigned a 2 digit group number from 02 to 99.
The Master Code is automatically assigned to group 01, and has full programming rights.
GROUPS 02-08: Management groups with 24/7 access.
GROUP 09: Group that allows the lock to be placed in passage mode when the code is entered. The lockset will re-lock when
code is entered again or at midnight of that day.
GROUPS 10-99: No programming rights. They may, however, change their own PIN (see “Change User PIN” on page 3).
IMPORTANT KEYS:
Acts like the “Enter” key on a computer, and is used to confirm entries on the keypad.
LED INDICATOR:
LED INDICATING GREEN (NORMAL MODE):
1.
Denotes lock enabled to open. Will flash green after valid entry and terminator key ( )
*
LED INDICATING RED (NORMAL MODE):
1.
Denotes a wrong code entry.
2.
Three consecutive wrong entries will disable keypad for 20 seconds. If another wrong code is entered, the keypad is
disabled for 40 seconds. This is indicated by a solid red light.
LED INDICATING RED (PROGRAMMING MODE):
1.
Denotes incorrect entry and vacates the programming mode.
2.
Programming mode vacated if no key entry within 5 seconds.
CREATE MASTER CODE
GROUPS
TO ADD USERS
Enter Master Code (User ID and PIN), the # key, (01), the key, the User ID you wish to add, the key, the 2 digit group number,
the key, the new PIN and the key twice.
*
*
*
*
*
*
Enter Master Code (User ID and PIN), the # key, (01), the key, the User ID you wish to delete, the key, the (0), and the
key twice.
*
*
*
Enter MASTER CODE
#
10
ADD USER CODE
(PIN)
* *
*
*
*
01
(User ID)
Enter 9991234
#
(PIN)
*
(User ID)
#
Enter MASTER CODE
DELETE USER CODE
* *
*
0
*
01
(User ID to be Deleted)
#
TERMINATOR KEY ( )
*
After a valid Master Code is entered, this key is depressed to enter the programming mode.
NOTE: At the end of any programming series, replace the last with a # to return to function number input.
This allows the programmer to perform multiple functions without having to re-enter the Master Code for
each function.
*
TO DELETE USERS