Adapter mounting instructions for agco combines – MacDon 873 Combine Adapter User Manual
Page 85
Form # 147069
Issue 09/06
83
Adapter Mounting Instructions
for Agco Combines
ADAPTER COMPLETION – GLEANER COMBINES:
1. Install upper beam (1) (from adapter package)
onto the adapter frame with two 1/2 x 1 inch
flange bolts (E) (one each side) and four
1/2 x 1 inch carriage bolts (C) and flange nuts
(D) (two each side).
NOTE: For attachment to adapter at top beam,
engage carriage bolts (C) in keyhole slots.
2. Attach left member (2) with three 1/2 x 1 inch
carriage bolts (C), one 1/2 x 1 inch flange bolt
(E) and flange nuts (D). Repeat at right side.
3. Insert lower latch support (4) onto adapter
frame as shown. Secure with 5/8 x 1-1/4 inch
carriage bolt (B), 5/8 x 2-1/2 inch carriage bolt
(A) and flange lock nuts (F). Repeat at other
side.
4. Install shields and other components.
A
BOLT – rnd hd, sq nk, 5/8 NC x 2-1/2”
B
BOLT – rnd hd, sq nk, 5/8 NC x 1-1/4”
C
BOLT – rnd hd, sq nk, 1/2 NC x 1”
D
NUT – lock, smth flng, 1/2 NC dist thd
E
BOLT – hex hd, serr flng, 1/2 NC x 1”
F
NUT – smth flng, 5/8 NC dist thread
G
BOLT – rnd hd, sq nk, 1/2 NC x 1-1/4”
H
BOLT – hex head, 5/8 NC x 1-1/2 inch
J
BOLT – hex hd, M12 x 1-3/4 x 25 long
K
WASHER – spring lock
P
BOLT – rnd hd, sq nk, 3/8 NC x 3/4
Q
NUT – smth flng, 3/8 NC dist thread
R
BOLT – hex head, 3/8 NC x 1-1/2 inch
S
BOLT – rnd hd, sq nk, 3/8 NC x 1 inch