MacDon 873 Combine Adapter - Manual (Page 77)

Form # 147069 Issue 09/06 75
Adapter Mounting Instructions
for Lexion Combines
PREPARING THE COMBINE (continued)
4. For Header Pitch (HP) Feeder House Combines:
Attach pump support arm (F – bent support – narrow
& wide header pitch feeder house) to right side of
combine feeder house tilting frame as follows:
NOTE: For Standard Feeder House Combines return
to step 3.
•
Remove bolt on shield from plastic shield on R/H
side of feeder house.
•
Cut 5-1/2” (140mm) hole in plastic shield as
shown.
•
Mount the pump support arm (F), using two 1/2 x
2 inch hex head bolts (K) and 1/2 inch locknuts
inserted through two holes, combine feeder
house and backing plate (M) as shown.
NOTE: For wide header pitch feeder house
combines, install second backing plate (M) on
outside of feeder house sandwiched between the
bent support (F) and feeder house.
NOTE: Slot in support arm (F) must line up with
frame pivot.
F
INSTALL SUPPORT ARM
HP – FEEDER HOUSE
K
N
INSTALL BACKING PLATE
HP - NARROW FEEDER HOUSE
M
N
INSTALL TWO BACKING PLATES
HP – WIDE FEEDER HOUSE
M
N
COMBINE SHIELD CUTTING