MacDon 873 Combine Adapter - Manual (Page 5)

Form # 147069 Issue 09/06 3
SPECIFICATIONS
FEED DRAPER DRIVE
Hydraulic: Pump driven from right side of feeder house, reversible
with combine feeder chain
FEED DRAPER SPEED 522 to 652 feet/min. (160 to 195 metres/min.) varies with combine
FEED DRAPER MATERIAL Self-tracking rubber coated polyester fabric with rubber slats
FEED DRAPER WIDTH:
John Deere, New Holland CX, Lexion 460, 465, 480, 480R, 485 & 485R, Challenger 670, MF 9790..... 55.9” (1420 mm)
Case 77, 80 & 88 Series, Case AFX, New Holland CR 970/980, Challenger 660, MF9690 ..........45.5” (1155 mm)
Lexion 450, 460R, 470, 470R, 475, 560, 560R, 570R, 575R, 580 & 580R, 585R .........................45.5” (1155 mm)
Case 60 & 66 Series, New Holland CR 920/940/960, Gleaner.......................................................38.4” (975 mm)
RETRACTING TINE DRUM DRIVE
Hydraulic: Pump driven from right side of feeder house, reversible
with combine feeder chain
RETRACTING TINE DRUM SPEED 146 to 180 RPM, varies with combine
RETRACTING TINE DRUM DIA. 11” (280 mm) with 1-1/4” (32 mm) flighting on ends
HEADER SIDE DRAPER DRIVE
Hydraulic: Pump driven from right side of feeder house
HEADER UPPER CROSS AUGER
DRIVE (OPTION):
Hydraulic: Pump driven from right side of feeder house
HEADER SICKLE DRIVE
Mechanical: Driveline from left side of feeder house
HEADER FLOTATION
Raised Frame Position: 7.3 inches (185 mm) vertical and 3.0 ° lateral
Lower Frame Position: 7.5 inches (190 mm) vertical and 4.8 ° lateral
HEADER REEL DRIVE
Hydraulic from combine oil supply
ADAPTER TO HEADER
TOP CENTER LINK:
Mechanical or Hydraulic from combine oil supply, (with solenoid
valve to toggle to reel fore-aft/header tilt options, if equipped)
SERIAL NUMBER LOCATION
Record the serial number in the space provided.
873 Combine Adapter:
Plate (A) is located on left side of adapter
frame.
NOTE: When ordering parts and service, be sure to give your dealer the complete and proper serial number.
COMBINE ADAPTER SERIAL PLATE
A