MacDon 9352c SP - Manual (Page 58)

Form # 147459 Issue 11/06 Web Rev_01 56
OPERATION
Storage Procedure
Do the following at the end of each operating
season:
CAUTION:
1. Clean the windrower thoroughly. Never use
gasoline, naphtha or any volatile material
for cleaning purposes. These materials may
be toxic and/or flammable.
2. Store windrower in a dry protected place.
Never operate engine in a closed building.
Proper ventilation is required to avoid
exhaust gas hazards.
3. Remove the battery. Bring to full charge and
store in a cool, dry place not subject to
freezing. Remember when working around
storage batteries that all of the exposed
metal parts are "live". Never lay a metal
object across the terminals because a spark
and short circuit will result.
4. Cover cutterbar and knife guards to prevent
injury from accidental contact.
Also:
5. If stored outside, always cover windrower with a waterproof tarpaulin or other protective material. This will
protect the switches, instruments, tires, etc. from inclement weather.
If no cover is available; seal air cleaner intake and exhaust pipe with plastic bags and/or waterproof tape.
6. If possible, block up windrower to take weight off tires. If it is not possible to block up the machine, increase
tire pressure by 25% for storage. Adjust to recommended pressure before next use.
7. Repaint all worn or chipped painted surfaces to prevent rust.
8. Lubricate the windrower thoroughly, leaving excess grease on fittings to keep moisture out of bearings.
Apply grease to exposed threads and sliding surfaces of components.
9. Check for worn components and repair. Tighten loose hardware and replace any missing hardware. See
Specifications section for torque charts.
10. Check for broken components and order replacements from your dealer. Attention to these items right
away will save time and effort at beginning of next season.
11. Add rust inhibitor to the engine oil.
Diesel Engine - use 10 oz (300 ml)
Run engine to operating temperature to mix inhibitor with oil.
12. To prevent condensation, fill hydraulic oil reservoir to filler neck with approved hydraulic system oil. See
"Fuels, Fluids and Lubricants" in Maintenance/Service section.
13. Test engine coolant anti-freeze concentration to ensure it is sufficient to protect engine against lowest
expected temperature.