MacDon M150 SP - Manual (Page 88)

HEADER - GENERAL
Form 169017 / 169087 / 169095
86
Revision C
2. If the header is below the pre-set height,
press and hold the HEADER UP switch to
raise the header. Release switch to stop
header. Alarm will sound when header rises
past the pre-set height.
3. If the header angle is changed, double-click
(two clicks within 0.5 seconds) the HEADER
TILT UP or HEADER TILT DOWN switch, and
the header will return to the pre-set angle.
NOTE
If the header cannot return to the pre-set
height or angle within 30 seconds, the
RETURN TO CUT feature will deactivate to
prevent the hydraulic oil from overheating.
Push the RETURN TO CUT switch to
reactivate.
6.4.6.2 Auto-Raise Height
a. Program the AUTO RAISE HEIGHT feature as
follows:
1. RETURN TO CUT switch can be “off” or “on”.
2. Press PROGRAM and SELECT on CDM to
enter programming mode.
3. Press SELECT. TRACTOR SETUP? is
displayed on upper line.
4. Press , then SELECT. SET KNIFE
SPEED? is displayed.
5. Press SELECT until AUTO RAISE HEIGHT is
displayed.
6. Press or to change value on
lower line. Range is 0.0 to 10.0, where 10.0
is fully raised.
7. Press PROGRAM to exit programming mode
when finished entering desired values.
b. Use the AUTO RAISE HEIGHT feature as follows:
IMPORTANT
The windrower must be running with the
header engaged at the cutting height, and
the RETURN TO CUT switch activated.
1. Double-click the HEADER UP switch on the
GSL to raise the header to the AUTO RAISE
HEIGHT set point.
NOTE
If HEADER UP is pressed while header is
being raised, AUTO RAISE HEIGHT is
temporarily disabled, and header will
maintain current height.
2. Momentarily press the HEADER DOWN
switch on the GSL to return the header to the
pre-set cutting height.
HEADER DOWN
RETURN TO
CUT
DISPLAY
HEADER UP