Display warnings and alarms – MacDon M150 SP User Manual
Page 44
OPERATOR’S STATION
Form 169017 / 169087 / 169095
42
Revision C
5.18.4.2 Display
Warnings
DISPLAY WARNINGS AND ALARMS
DISPLAY
FLAS
H
ING
ALARM TONE
DESCRIPTION
BRAKE OFF
Engine Running,
Brake Solenoid Not Activated.
BRAKE ON
9
Short Beep With Each Flash.
GSL Out Of N-Detent But Interlock
Switch Remains Closed To Apply Brake.
BRAKE SW FAILURE
Ignition On / Engine Not Running,
Brake Switch And Relay Closed.
CAB-FORWARD SW ON /
ENG FORWARD SW ON
9
Messages Flash Alternately.
Both Seat Switches Activated.
CENTER STEERING
Beeps At 2 Per Second.
GSL or Interlock Switches Not Closed
With Key On/Engine Off.
DISENGAGE HEADER
RE-ENGAGE <1800RPM>
9
None
R80 - Engine RPM Above 1800.
ENGINE AIR FILTER
9
Single Loud Tone For 10 Seconds.
Repeats Every 30 Minutes Until
Condition Is Corrected.
Engine Air Filter Requires Servicing.
ENGINE OIL PRESSURE
9
Continuous Loud Tone Until Oil
Pressure Is Regained.
Low Engine Oil Pressure.
ENGINE TEMPERATURE
9
Ongoing Intermittent Moderate
Tone Until Temperature Is Below
215°F (102°C)
Engine Temperature Over 230°F (110°C)
HEADER DISENGAGED
None
Normal
DISENGAGE HEADER
9
None
Header Switch Is In On Position When
Ignition Switch Turned On.
HEADER OIL PRESS
9
Continuous Loud Tone Until Oil
Pressure Is Regained.
Low Header Charge Oil Pressure.
Header Shuts Down Automatically.
Header On Switch Must Be Moved To
Off Position, And Then To On Position
To Restart The Header.
HYDRAULIC FILTER
9
Single Loud Tone For 10 Seconds.
Repeats Every 15 Minutes Until
Condition Is Corrected.
Excessive Pressure Increase Across
Hydraulic Oil Filter.
DISPLAY WARNINGS
Informs Operator of Abnormal
Windrower Conditions
See Table Below