MacDon M150 SP - Manual (Page 32)

OPERATOR’S STATION
Form 169017 / 169087 / 169095
30
Revision C
5.17.3 GROUND SPEED LEVER (GSL)
HEADER SWITCHES
The GSL (A) contains switches for the following
header functions that are most often adjusted
while in operation to suit changing crop conditions.
All are momentary type switches.
A decal that identifies the switch functions is
located on the cab post above the Operator’s
console.
5.17.3.1 Display Selector Switch
Selects and displays the settings in the CDM (B)
top line read-out for each of the header controls.
• Press switch to scroll through settings.
5.17.3.2 Reel Position Switches
The reel position switches perform the following
functions, depending on CDM programming, and
which header is attached:
• Double Windrow Attachment (DWA) Position
on Draper and Auger Headers. See Section
6.4.7
• Reel Fore-Aft Position and Height on Draper
Headers. See Sections 6.5.4 and 6.5.5.
• Grass Seed Drum Position on Rotary
Headers. See Section 6.7.4.
• Center-link Assist Cylinder. See Sections
6.5.1, 6.6.1, or 6.7.1.
NOTE
Refer to the specific Header section in this
instructional manual for detailed switch
operating modes.
DISPLAY
SELECTOR
REEL UP
REEL AFT
REEL FORWARD
REEL DOWN
DWA DOWN
DWA UP
A
B