MacDon M150 SP - Manual (Page 35)

OPERATOR’S STATION
Form 169017 / 169087 / 169095
33
Revision C
5.18 CAB DISPLAY MODULE (CDM)
5.18.1 ENGINE AND WINDROWER
FUNCTIONS
5.18.2 HEADER FUNCTIONS
FLOAT SWITCH - HEADER RIGHT SIDE
Changes Header Float
Push + to Increase / Push - to Decrease
Remembers Setting With Deck Shift Option If
Activated With Float Setting Switch
AUGER / DRAPER SPEED ADJUST
Changes Auger / Draper Speed INDEX with INDEX SWITCH ON
Changes Auger / Draper SPEED with INDEX SWITCH OFF
Push Upper Switch to Increase
Push Lower Switch to Decrease
DISPLAY
Header Functions
HEADER INDEX SWITCH
Links Reel and Conveyor Speed to Ground Speed.
Push-On / Push-Off
Illuminates In On Position
SELECT SWITCH
Allows Operator To Select Display Item.
Bottom Line
Push To Select
RETURN TO CUT HEIGHT SWITCH
Allows Cutting Height Pre-Set.
Push-On / Push-Off
Illuminates In On Position
FLOAT SWITCH - HEADER LEFT SIDE
Same As Above
NOTE
HEADER MUST BE ENGAGED.
HAZARD WARNING LIGHTS SWITCH
Activates Hazard Warning Lights
Cancels Turn Signal
TURN SIGNAL SWITCHES
Activates Turn Signals on Windrower and Header
Push-On / Push-Off
GROUND SPEED
mph or kph
ENGINE RPM
DISPLAY
Engine / Windrower Functions
IGNITION SWITCH POSITIONS
Accessory / Stop / Run / Start
SELECT SWITCH
Allows Operator To Select
Display Item On Lower Line
Push To Select
ENGINE WARNING LIGHTS
Engine Pre-Heat / Water In Fuel /
Do Not Operate / Stop Engine