MacDon M150 SP - Manual (Page 165)

MAINTENANCE AND SERVICING - M200 ENGINE
Form 169017 / 169087 / 169095
163
Revision C
e. Change secondary filter (D) as follows:
1. Thoroughly clean around the filter head (L).
2. Remove filter (D) with a filter wrench, and
safely dispose of the filter.
3. Lubricate O-ring seal with clean engine oil.
Do not fill canister with fuel before canister is
installed.
4. Screw the new filter (D) onto the filter mount
until the gasket contacts the filter head.
5. Tighten the filter an additional ½ to ¾ turn by
hand.
IMPORTANT
Do not use a filter wrench to install the filter.
Over-tightening can damage the gasket and
filter.
f. Open fuel valve (E) under fuel tank.
g. Push the priming pump (M) until glass bowl is full,
and resistance is felt on the pump. If engine does
not start, repeat this procedure.
h. Close engine compartment hood.
i. Remove the container, and dispose of the fluid in
a safe place.
7.9.6.3 Separator
A fuel water separator is incorporated into the
primary fuel filter. Drain the water and sediment
as follows from the separator daily.
DANGER
Stop engine and remove key from ignition
before leaving Operator’s seat for any reason.
A child or even a pet could engage an idling
machine.
a. Stop engine, and remove key.
b. Place a suitable container under primary filter.
Install a suitable tube onto the water separator
drain (B).
c. Turn drain valve (B) by hand 1½ to 2 turns counter
clockwise, and allow fluid to drain into the
container.
d. Drain the filter sump of water and sediment until
clear fuel is visible in glass bowl.
e. Turn the valve clockwise to close the drain.
E
B
D
L M