MacDon M150 SP - Manual (Page 210)

MAINTENANCE AND SERVICING
Form 169017 / 169087 / 169095
208
Revision C
7.14 MAINTENANCE SCHEDULE
The Maintenance Schedule (see next page)
specifies the periodic maintenance procedures
and service intervals. Regular maintenance is the
best insurance against early wear and untimely
breakdowns. Following this schedule will increase
machine life.
For detailed instructions, refer to Section 7
MAINTENANCE AND SERVICING. Use the fluids
and lubricants specified in Section 7.3.1
Recommended Fuel, Fluids and Lubricants.
Service Intervals: The recommended service
intervals are in hours of operation. Where a
service interval is given in more than one time
frame, e.g. "100 hours or Annually", service the
machine at whichever interval is reached first.
IMPORTANT
Recommended intervals are for average
conditions. Service the machine more often
if operated under adverse conditions
(severe dust, extra heavy loads, etc.).
CAUTION
Carefully follow safety messages given under
Section 7.1 PREPARATION FOR SERVICING,
and Section 7.2 RECOMMENDED SAFETY
PROCEDURES.
7.14.1 BREAK-IN INSPECTIONS
BREAK-IN INSPECTIONS
HOURS ITEM CHECK
EVERY
.25 Road or
1 in Field
Drive Wheel Nuts
Torque - 220 ft·lbf (300 N·m).
Repeat Checks Until Torque Stabilizes.
5
A/C Belt Tension.
Caster Wheel Nuts Torque - 120 ft·lbf (163 N·m).
Caster Wheel Anti-Shimmy Dampener Bolts
Inboard Bolt Torque - 100 ft·lbf (135 N·m).
Outboard Bolt Torque - 85 ft·lbf (115 N·m).
Walking Beam Width Adjustment Bolts Torque - 330 ft·lbf (448 N·m).
10
Walking Beam Width Adjustment Bolts Torque - 330 ft·lbf (448 N·m).
Drive Wheel Nuts Torque - 220 ft·lbf (300 N·m).
Neutral Dealer Adjust.
50
Hose Clamps - Air Intake / Radiator / Heater / Hydraulic Hand Tighten Unless Otherwise Noted.
Walking Beam Width Adjustment Bolts Torque - 330 ft·lbf (448 N·m).
Caster Wheel Anti-Shimmy Dampener Bolts
Inboard Bolt Torque - 100 ft·lbf (135 N·m).
Outboard Bolt Torque - 85 ft·lbf (115 N·m).
Drive Wheel Nuts Torque - 220 ft·lbf (300 N·m).
Drive Wheel Lubricant Change.
Main Gearbox Oil Change.
Hydraulic Oil Filters Change.