MacDon M150 SP - Manual (Page 193)

MAINTENANCE AND SERVICING
Form 169017 / 169087 / 169095
191
Revision C
7.11.9 GAUGE LIGHT
a. Shutdown engine, and remove the key. Turn off
the lights.
b. Remove the appropriate gauge access hole decal
(A) behind the Operator’s console.
c. Remove nut (B) securing mounting bracket (C) to
gauge inside the console.
d. Pull gauge out from console. It is not necessary to
disconnect the wiring harness to back of gauge.
e. Twist bulb holder (D) counter clockwise until
loose, and pull bulb holder from back of gauge.
f. Insert new bulb into gauge, and turn clockwise
until it locks.
g. Push gauge into console.
h. Locate bracket (C) onto back of gauge, and
secure with nut (B). Tighten nut to 75 - 96 in ·oz
(530 - 678 mN·m).
i. Replace gauge access-hole decal (A).
7.11.10 DOME LIGHT
a. Shutdown engine.
b. Remove two screws (A) from plastic lens, and
remove lens.
c. Replace bulb.
d. Reinstall plastic lens with screws (A).
7.11.11 AMBIENT LIGHT
a. Shutdown engine.
b. Push against tabs (B) with a screwdriver, and pull
ambient light fixture out of cab roof.
c. Remove connectors (C).
d. Connect wires to new light fixture.
e. Push into place in cab roof until tabs hold fixture in
place.
7.11.12 TURN SIGNAL INDICATORS
If the turn signal indicators on the CDM do not
function, contact your Windrower Dealer.
B
C
A
B
C
D
A