MacDon M150 SP - Manual (Page 153)

MAINTENANCE AND SERVICING - M150 ENGINE
Form 169017 / 169087 / 169095
151
Revision C
7.8.8.2 Changing Lubricant
Change gearbox lubricant after the first 50 hours,
and then at 500 hours as follows:
NOTE
The engine should be warm prior to
changing the oil.
a. Stop the engine, and remove the key.
b. Place a drain pan of about 1 U.S. gallon (4 litres)
under the gearbox.
c. Remove drain plug (C), and allow the oil to
completely finish draining.
d. Install the drain plug (C), and remove the check
plug (A).
e. Unscrew breather cap (B), and add lubricant. The
gearbox will require 2.2 U.S. quarts (2.1 litres).
Add sufficient lubricant until it slightly runs out of
hole (A). Use SAE 75W-90 API Service Class GL-
5, Fully Synthetic Transmission Lubricant.
SAEJ2360 preferred.
f. Operate the engine at low idle, and check for
leaks at the check plug and drain plug.
A
B
C