MacDon M150 SP - Manual (Page 112)

HEADER OPERATION - R SERIES
Form 169017 / 169087 / 169095
110
Revision C
d. Connect center-link as follows:
MECHANICAL LINK - M150
1. Loosen nut (F), and rotate barrel (G), to adjust
length so that other end lines up with header
bracket.
2. Install clevis pin (H), and secure with cotter
pin.
3. Adjust link to required length for proper
header angle by rotating barrel (G). Tighten
nut (F) against barrel. A slight tap with a
hammer is sufficient.
4. Proceed to step e.
HYDRAULIC LINK WITHOUT SELF-ALIGNMENT
KIT - M200 STD, M150 OPTION
1. Relocate the pin at the frame linkage as
required to position the hook over the header
pin.
2. Activate HEADER TILT cylinder switches on
GSL to extend or retract center-link cylinder
so that the hook lines up with the header
attachment pin.
3. Push down on rod end of link cylinder (J) until
hook engages pin (K) on header and is
locked.
4. Check that center-link is locked onto header
by pulling upward on rod end of cylinder.
(continued next page)
G
F
J
K
HEADER UP
HEADER TILT UP
HEADER DOWN
HEADER
TILT DOWN
H
G