Opticon ESL - Manual (Page 19)

Opticon ESL
DEMO KIT
User Manual
19
5.4. Configuring of ESLs
Besides sending images to the ESL, there are a number of configurations that can be
made in the ESLs to control, customize and to regulate power consumption.
To edit configurations of an ESL, go to the base station tab to which the ESL is currently
linked and right click on the ESL. After doing so, a settings dialog should appear, showing
the current status and settings of that ESL. (If the base station has not yet received the
settings from this ESL, then it will automatically request the settings the next time the ESL
sends a poll for data.)
To edit configurations, check the checkbo
x „Edit Settings‟ in the left bottom corner. After
that, there will be 5 configurations that can be edited. These configurations will be
described in the following chapters:

Associate Interval

Poll info ratio

Poll interval

Poll timeout

Scan channels
To edit multiple ESLs at the same time, press the shift- or ctrl-key in the base station tab to
select and configure multiple ESLs at the same.