Lenze E94AYCIB - Manual (Page 8)

1 About this documentation
1.3 Terminology used
8
Lenze · E94AYCIB communication module (INTERBUS) · Communication Manual · DMS 4.0 EN · 02/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1.3 Terminology used
Term Meaning
Drive Lenze inverter of the "Servo Drives 9400" product series, with which the
communication module can be used.
 Application as directed ( 12)
Inverter
Standard device
Code
Parameter which serves to parameterise and monitor the drive. In normal usage,
the term is usually referred to as "Index".
Subcode If a code contains several parameters, they are stored in "subcodes".
In the documentation, the slash "/" is used as a separator between the code and
the subcode (e.g. "C00118/3").
In everyday language, the term is also referred to as "subindex".
»Engineer« Lenze PC software which supports you during the "Engineering" process
(parameterisation, diagnostics, and configuration) throughout the whole life
cycle, i. e. from planning to maintenance of the machine commissioned.
INTERBUS was developed as sensor/actuator bus system for transmitting
process data.
Maintenance activities for the INTERBUS technologies are carried out by the user
organisation PROFIBUS & PROFINET International (PI).
Host PLC, INTERBUS master
PCP Peripherials Communication Protocol for transmitting parameter data
PDO Process data object
PDU Process Data Unit
PMS Peripheral Message Specification
HW Hardware
SW Software