Black Box 5000 - Manual (Page 57)

CHAPTER 6: Getting Started
55
6.4 Reset Defaults
Use one of the following methods to ensure that the
Multiserver’s configurations are set to standard
default values.
• Enter the Command Facility Main Menu to
perform a cold start.
• Perform a cold start using the front-panel
keypad. Refer to Figure 6-2.
• Jumper E1 is located on the CCM board near
the front of the Multiserver (see Figure 4-9 on
page 40). Unplug the Multiserver and then
remove the Commpak
. Use a small pair of pliers
and remove Jumper E1 for 15 minutes. All
power will slowly drain from the CMOS during
this time. The CMOS’s memory will be erased
and it will revert to its factory-set defaults.
COMMAND FACILITY MAIN MENU [node id]
RESET 10
RESET [node id]
NODE 1
ENTER A “Y” TO CONFIRM
OR “N” TO ABORT: Y
PARAMETER RESTORATION
DEFAULT VALUES 1
Banner
Message
⇒
Menu Functions
⇓
Administration
⇓
System
⇓
Clear Latched
Alarms
⇒
System Reset
⇓
Default
Configurations
⇓
E EX XE E , E EX XE E
(Press twice)
Key:
⇒
Press right arrow
Figure 6-2. Cold start using
the LCD/Keypad Menu.