Black Box 5000 - Manual (Page 170)

Multiserver 5000
168
C HANNEL N UMBERS
When the LCD display requests you for a channel
number, use the following keys as shown.
The default channel number display is A01; the
cursor will be positioned beneath the A.
• If the port desired is A5, you will not change the
A. Move the cursor right with the right arrow
key to the 1 (A01) and press the down arrow key
four times. The 5 appears on the display. After
the display shows the complete input, accept the
entry by pressing the EXEcute key.
• If the port desired is B1 that is the desired port
number, be sure the cursor is below the A and
press the down arrow once. The display will
now read B. All three positions of the port
selection can be altered in this manner.
13.2 Banner Message Display
The Banner Message is the top level of the LCD
menu system. The configurable banner message is
displayed on the top row, left side of the display.
The current time is displayed on the top row, right
side. The banner message and time can be set only
from the Command Facility.
Alarms and events are displayed on the second line
of the Banner Message Display, along with the time
of the alarm or event. For alarm messages, the
backlight blinks. For event messages, the backlight
is steady.
Denver 11:35:47
8:49:03 Local Link reset A1
Banner Message
Time when alarm/
event occurred
Alarm/Event Message
Current Time
Figure 13-3. The LCD Banner Display.
COMMAND FACILITY MAIN MENU [node id]
CONFIGURE LOCAL NODES 3
CONFIGURE LOCAL NODES [node id]
COMMAND FACILITY PARAMETERS 7
COMMAND FACILITY PARAMETERS
LCD BANNER MESSAGE 14
ENTER LCD BANNER MESSAGE
(^X TO ABORT):
EXE
EXE
Move cursor to the left
Abort process, move to previous menu
Increment letter/number by one (If key is
held, the character will increment rapidly.)
Move cursor to the right
Accepts entry