Black Box 5000 - Manual (Page 105)

CHAPTER 9: Data-Channel Configuration
103
9.5 Review Data-Channel Configuration
R EVIEWING S YNC -C HANNEL C ONFIGURATION
To review sync-data channels, enter the View
Configuration menu.
At
this prompt, enter the node ID, a slash, and a sync
channel or range of channels you wish to review.
(Channel ranges should be in the form: starting
channel, dash, ending channel. For example,
channels B1 through B6 would be entered as B1-
B6
.) All sync channels in the range will be
displayed. If there are non-sync channels in the
range, they will not be displayed.
All of the sync characteristics are discussed in
Section 9.2
and Table 9-3. Any characteristic that
has dashes (--) is not configurable for that
protocol.
COMMAND FACILITY MAIN MENU [node id]
VIEW CONFIGURATION 1
VIEW CONFIGURATION [node id]
SYNC CHANNELS 2
[node id] SYNC CHANNELS CHARACTERISTICS
DATA CLOCKING BLOCK SIZE DTE CAR BUFF FLOW DSR
CH PROTOCOL RATE TX RX TX RX DCE MODE CNTRL CNTRL CNTRL
---------------------------------------------------------------------------
A02 DLC 2400 INT INT 512 512 DTE CON NONE ENA NORMAL
A03 RTS/CTS 2400 INT INT 512 512 DTE VAR NONE ENA NORMAL
[node id] SYNC CHANNELS CHARACTERISTICS
SYNC LEAD PAD LEAD TRAIL IDLE DATA
CH PROTOCOL CHAR SYNCS CHAR PADS PADS ENCODE FILL INV PRI
---------------------------------------------------------------------------
A02 DTR ----- -- -- -- -- NRZ FLAG ---- LOW
A03 RTS/CTS FF FF 03 FF 03 03 ------ --- ---- LOW
ENTER CARRIAGE RETURN TO CONTINUE
ENTER NODE-ID/CHANNEL# (OR RANGE
OF CHANNELS)(^X TO ABORT):