INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 69)

4 - 7
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
The Start/Stop button (see Figure 4-11 ) on the Control Panel serves a dual
purpose. When data is being collected, the button can be used to stop collection,
which also stops the display. When data collection is stopped, the button can be
used to start collection and the display. Stopping data collection results in the data
being saved to disk, if the Auto Save Monitor function is enabled, or discarded.
Starting data collection from this button starts a new collection session. There is an
equivalent Start/Stop button on the toolbar.
Figure 4-11 The Pause and Stop buttons
CAUTION
Stopping the data collection when Auto Save Monitor is
not checked will discard all data collected since the
Monitor was started. There is no warning or prompt when
this action is taken.
Zoom In ( ) provides an adjustable rectangle on the Trend Graph that will
display the data from within the rectangle across the full width of the graph.
After using the Zoom In feature, the Zoom Out ( ) button can be used to
return all the data to the Graph. Clicking outside the graph area has the same
effect.
The Rescale button ( ) can be used to show the full height of the data.
4.3 Editing the Configuration
The Configuration Editor is available while collecting data so that changes can
be made and the effect of the changes can be seen in real time. Three functions
exist to edit the Configuration while collecting data — Edit Current Configuration,
New Configuration and Open Configuration. Each function is accessed from the
Monitor menu (see
Figure 4-12 ).