INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 48)

3 - 6
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
All of the parameters can be listed within the Main Window by clicking on each plus
sign [+] at the front of any Parameter Group name. For instance, to list the
parameters within the General Parameters, click on the plus sign that precedes
General Parameters (see
Figure 3-9 ). The result of that action will be a list of all
General Parameters (see Figure 3-10 ).
Figure 3-9 The General Parameters branch
Figure 3-10 Expanding the General Parameter branch
The following describes the entry points and Toolbar buttons on the Main Page
(refer to
Figure 3-8 on page 3-5 ):
Controller Name . . . . . . . . . . . . . . . The name of the XTC/3 Controller for which
this Configuration is intended. Select the
name from the drop-down list if XTC/3
Controller icons have been placed on the
System Setup screen.
The first line in the Controller Name list is
blank. This can be selected when creating a
Configuration for a controller which is off-line
or attached to a different computer. When