INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 23)

1 - 11
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
1.10 Where To Go From Here
This Operating Manual is intended to make the process of setting up, installing, and
using the XTC/3 Editor a pleasurable and trouble-free experience. Please, take a
few moments to look through it and become familiar with its contents.
The information in this manual is organized into the following chapters:
Chapter 1, Getting Started
An introduction to the XTC/3 Editor application, provides instructions on how to
install and run the XTC/3 Editor, and explains how to use this Operating
Manual.
Chapter 2, Setup
A description of how to set up the software and communications ports for your
installation and customize it to your preferences.
Chapter 3, Editing Configurations
Describes how to edit, save and send Configuration files, which specify the
measurement parameters for the XTC/3 Controller.
Chapter 4, Monitor
Describes how to acquire, save, recall and report XTC/3 Controller data.