INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 27)

2 - 3
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
Figure 2-3 System Properties Page
Three buttons are provided on the Port Settings tab which affect the port
highlighted in the list: Add Port, which is described in
section 2.2.1 on page 2-4 ,
Properties for Serial communications and XTC3 Controller List for Ethernet
communications, which is described in
section 2.2.1 on page 2-4 , and Remove,
which deletes the port and any associated parameters from the System Properties.