INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 67)

4 - 5
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
The maximum file size allowed for any data file is 11MB. It is the responsibility of
the user to manage data files, data archiving and hard disk storage.
4.2.4.1 The Display Smoothing Setting
The effective noise of the displayed data can be filtered by changing the
Smoothing setting (see
Figure 4-7 ). Smoothing provides an averaging of data
points before the point is displayed, but has no impact on the raw data collected
and saved. Smoothing only affects the display of Rate or Rate Deviation.
Figure 4-7 Changing Smoothing
4.2.4.2 Setting a Mark
The Set Mark button (see Figure 4-8 ) on the Control Panel allows for a Mark and
text description to be applied to the data. The Set Mark function will Freeze the
graph and provide a crosshair cursor ( + ) to select the data scan to be marked.
Text information (for the Marks History log) can be added in the Set Mark dialog
(see
Figure 4-9 ). That Mark is then indicated along the X-axis with a colored
diamond (see Figure 4-10 ).
Marks are automatically generated for:
Š the start of the Monitor, to store a "benchmark" of the crystal status
Š any Crystal status change — Crystal Good, Crystal Invalid, Crystal Failure
Š any controller state change — Ready, Idle, Deposit, etc...
Figure 4-8 Set Mark button