INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 60)

3 - 18
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
Figure 3-25 Editing a Process Name
In Figure 3-24 the Empty Process menu item is grayed out. This is because this
process has been selected as the Process To Run in the General Parameters.
(Refer to
section 3.5, Editing the General Parameters, on page 3-10 .)
The content of a process, e.g. layers, can be copied to one or more processes.
Select a process, right-click and select Paste process to.... See
Figure 3-26 .
Figure 3-26 Pasting a Process
The dialog box similar to the one shown in Figure 3-27 will be displayed. From the
list shown, select one or more processes and click OK. A progress bar will show
which processes are being copied.