INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 52)

3 - 10
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
3.5 Editing the General Parameters
Figure 3-12 shows the General Parameters dialog box of the XTC/3 Editor. This
box sets the general parameters that are not specific to any I/O, film or process.
Figure 3-12 General Parameters Page
To edit any parameter, enter the desired value in the Value column or use the
corresponding pulldown. Any parameter can be sent to the XTC/3 Controller by
selecting the parameter in the Send column and pressing the Send Selection
button on the toolbar. Clicking on the header of the Send column will select all
parameters. The entire page of parameters can be sent by pressing the Send All
button (regardless of the Send column selections). The OK button will save all
changes to the Editor memory; the Cancel button will discard all changes.
For specific information on any General Parameter, refer to the XTC/3 Thin Film
Deposition Controller Operating Manual (IPN 074-446-P1).