INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 47)

3 - 5
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
3.3 Configuration Editor Main Window
Figure 3-8 shows the Main Window of the Configuration Editor. The Controller
Name and Config Name appear in this window to identify which XTC/3 Controller
this Configuration is for and in which file this Configuration will be stored (the Config
Name entry will be blank if editing a new configuration). The Controller Name is
not stored in the XTC/3 Controller, it is simply a text field used on the PC to identify
the intended target for the Configuration file.
The Main Window is the only window from which the entire Configuration file can
be saved to disk and sent to the controller. Editing of each individual page is
launched from this window by double-clicking on either a Parameter Group name
or individual parameter name within the Main Window.
Figure 3-8 Configuration Editor: Main Window