INFICON XTC/3 Thin Film Deposition Controller Software Editor Operating Manual - Manual (Page 55)

3 - 13
IP
N 07
4-
45
2-
P1
A
XTC/3 Editor Operating Manual
3.7 Editing Film Parameters
Figure 3-16 shows the Film 1 parameter set for the XTC/3 Editor. The Film 1
Parameters dialog box sets the Film Parameters that are specific to Film 1 for the
XTC/3 Controller.
Figure 3-16 Film Parameters Page
To edit any parameter, enter the desired value in the Value column or use the
corresponding pulldown or spinner. Any parameter can be sent to the XTC/3
Controller by selecting the parameter in the Send column and pressing the Send
Selection button. The entire set of parameters can be sent by pressing the Send
All button (regardless of the Send column selections). The OK button will save all
changes to the Editor memory; the Cancel button will discard all changes.
For specific information on any Film Parameter, refer to the XTC/3 Thin Film
Deposition Controller Operating Manual (IPN 074-446-P1).