INFICON SQM-242 Thin Film Deposition Controller Card Operating Manual - Manual (Page 69)

7 - 15
IP
N 07
4-
54
9-
P1
A
SQM-242 Operating Manual
7.2.5 Crystal Snatcher
Use the crystal snatcher, supplied with the sensor, as follows:
1 Insert crystal snatcher into ceramic retainer (1) and apply a small amount of
pressure. This locks the retainer to the snatcher and allows the retainer to be
pulled straight out (2). See
Figure 7-6 .
2 Reinsert the retainer into the holder after the crystal has been replaced.
3 Release the crystal snatcher with a slight side-to-side motion.
Figure 7-6 Use of the Crystal Snatcher