INFICON Sensistor ILS500F Leak Detection System User Manual
Sensistor ils500 f, Leak detection filler
This manual is related to the following products:
Table of contents
Document Outline
- 1 General Information 8
- 2 Equipment and Storage 10
- 3 ILS500 F Description 12
- 4 Setup 18
- 5 Menu System 27
- 6 Using the ILS500 F 35
- 7 Recipes 38
- 8 Troubleshooting 50
- 9 Maintenance Instructions 62
- 10 Service 70
- 11 Technical Data 71
- 12 Spare Parts and Accessories 84
- 13 Support from INFICON 85
- 14 Declaration of Conformity 86
- 15 Declaration by the Manufacturer 87
- 1.1 About This Manual
- 1.2 Introduction to the ILS500 F
- 1.3 Disposal
- 2.1 Supplied Equipment
- 2.2 Required Equipment
- 2.3 Storage
- 3.1 Front View
- 3.2 Rear View (Electrical)
- 3.3 Configuring Ports and Interfaces (Electrical)
- 3.4 Rear View (Pneumatical)
- 3.5 Configuring Ports and Interfaces (Pneumatical)
- 3.6 Labels
- 4.1 Placement of the ILS500 F
- 4.2 Electrical Connections
- 4.3 Pneumatic Connections
- 4.4 Connect External Leak Detector
- 4.5 Set Up Test Area
- 5.1 ILS500 F Display
- 5.2 Passwords
- 5.3 Menu Overview
- 6.1 Test Sequence
- 6.2 Run a Test
- 7.1 Recipe Overview
- 7.2 Create a Recipe
- 7.3 Test Settings
- 7.4 Optimizing the Test Cycle
- 8.1 Fault Symptoms
- 8.2 Perform Hardware Test
- Pressure and Vacuum Sensors
- Evacuation Valve
- Venturi Pump
- Manifold Tightness (gross)
- Vacuum Sensor Valve
- Tracer Gas Fill Valve
- Test Port 2 Valve
- Tracer Gas Fill Valve
- External Gas Leaks
- Manifold Tightness (gross)
- Evacuation Valve
- Indicator Lamps
- START and STOP buttons
- 8.2.1 Hardware Error Messages
- 8.2.2 Interpretation of Hardware Test Results
- 9.1 Maintenance Plan
- 9.2 Maintenance
- 9.3 Functional Verification
- 11.1 Electrical Specifications
- 11.2 Pneumatic Specifications
- 11.3 Other Data
- 11.4 Interfaces and Connectors
- 13.1 How to Contact INFICON
- 13.2 Returning Components to INFICON