INFICON Sensistor ILS500F Leak Detection System - Manual (Page 79)

Technical Data 79
ninp69e1-a (1410)
11.4.6 Control Output
Pin Signal Type Load Comment
1 +24 VDC SUPPLY 300 mA Tooling switch supply (e.g. proximity
switch).
2 TS1 IN -7 mA Tooling switch 1.
3 TS2 IN -7 mA Tooling switch 2.
4 TS3 IN -7 mA Tooling switch 3.
5 TS4 IN -7 mA Tooling switch 4.
6 MARKER* OUT 0.5 A Marker output. Selectable mark on
REJECT or ACCEPT.
7 COM GND -1.0 A Common GND.
8 COM GND -1.0 A Common GND.
* MARKER output (Tooling Connector, pin 6) can be used to send a start pulse to
marking equipment such as an engraving machine or a valve controlling a simple
pneumatic stamp. Function and length of pulse is set by the following two
parameters:
Marker Output: Length of marker output pulse.
Output will go high at end of gas test and stay
high for the given time.
Marker Output High if Leak: Decides function of marker pulse.
To mark rejected part set to OFF.
To mark accepted part, set to ON.
Connector: 8 pin male Weidmüller, Omnimate BL3.5. Mating screw terminal
included.
Purpose: External start and stop. Control of optional external valves.
Pin Signal Type Load Comment
1 +24 VDC SUPPLY 2.0 A Start and stop switch and supply.
2 EXTSTART IN -7 mA Start button return (NO contacts) or
contact to +24 VDC.
3 EXTSTOP IN -7 mA Stop button return side (NO contact) or
contact to +24 VDC.