INFICON Sensistor ILS500F Leak Detection System - Manual (Page 78)

78 Technical Data
ninp69e1-a (1410)
11.4.4 Status Output
11.4.5 Tooling Interface
Connector: 6 pin male Weidmüller, Omnimate BL3.5. Mating screw terminal
included.
Purpose: Test Status Outputs. Sourcing 24 VDC transistor outputs.
Pin Signal Type Load Comment
1 RUNNING OUT 0.5 A Cycle running.
2 ACCEPT OUT 0.5 A Tested part accepted.
3 REJECT OUT 0.5 A Tested part rejected.
4 ERROR OUT 0.5 A Summing error.
5 EOT/FILLED OUT 0.5 A End of test or gas filled indicator
(selectable).
6 COM GND -2.0 A Common GND.
Notice Gas filling status is available on the STATUS connector (pin 5) on the back
of the unit. Connect to a lamp for easy notification of “End of test” status.
Connector: 8 pin male Weidmüller, Omnimate BL3.5. Mating screw terminal
included.
Purpose: Electrical tooling interface.