HYDAC CSI-F-10 - Manual (Page 64)

GSM Radio Module CSI-F-10 Page 64
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
7.1.6 Set bus address
The Set bus address function is a general CMWIN function, but which cannot be
used on a CSI-F-10 GSM radio module which is directly connected. A CSI-F-10
directly connected to a PC generally has the address "Bus master", which cannot
be altered.
Warning!
If you try to change the bus address of the CSI-F-10, an error message appears.
7.1.7 Managing sensor constellations
The sensor constellation is a monitoring instrument for the connected sensor
system, i.e. it continually compares the connected “Actual“ sensor system with the
specified “Target“ sensor system (see Chap. 8.1.5. Sensor constellation).
You can use this function to generate and manage various sensor constellation
files. These constellation files can, like the configuration files, be generated on a
"Master" device and then loaded onto an unlimited number of other CSI-F-10.
If no sensor constellation has yet been generated in the device then the following
window opens:
• You can generate a new sensor constellation in the device by pressing Create
(in the upper command bar). Afterwards, the following message appears:
• Press Display (in the upper command bar) to display the actual sensor
constellation currently in the device.
• Press Delete (in the upper command bar) to delete the actual sensor
constellation currently in the device.
All other functions in the lower command bar (Open, Load, Save, Delete, etc.) and
the selection of the target folder for saving the files are identical with Chapter 7.1.5
"Managing configurations".