HYDAC CSI-F-10 - Manual (Page 113)

GSM Radio Module CSI-F-10 Page 113
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
10.4.3 Invalid Digital Output
The quantity of digital outputs is device-dependent. This error is set when an output
terminal is selected that a device doesn't have.
► Check the selection and correct it.
10.4.4 Duplicate Digital Ouput
The output terminal of the digital output must not occur more than once in a CM
program.
► Check the output terminal which has been set and correct it.
10.4.5 Too Many Boolean Output Fields
The quantity of Boolean output fields in one CM program is device-dependent.
► Reduce the Boolean output fields to the device-specific maximum.
10.4.6 Duplicate Boolean Output Field
The inscription of a Boolean output field must not occur more than once in a CM
program.
► Check the inscription and correct it.
10.4.7 The Bit Number Must Be a Figure between 0 and 14
The property "Bit number" must not lie outside the range of 0 ... 14 for the Boolean
output field function.
► Check the value that was entered and correct it.
10.4.8 Too Many Numerical Output Fields
The quantity of numerical output fields in one CM program is device-dependent.
► Reduce the numerical output fields to the device-specific maximum.
10.4.9 Duplicate Numerical Output Field
The inscription of a numerical output field must not be present more than once in a
CM program.
► Check the inscription and correct it.
10.4.10 Message and telephone number too long
The length of the message + telephone number together is limited to 230 characters.
► Check the relevant entries and correct them.