HYDAC CSI-F-10 - Manual (Page 112)

GSM Radio Module CSI-F-10 Page 112
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
10.2.9 No Inscription for Numerical Input
The numerical input value must have an inscription.
► Enter an inscription in the function properties.
10.2.10 Duplicate Inscription for Numerical Input
The inscription of a numerical input value must be unambiguous within a CM program
and is only permitted to occur once for that reason.
► Check the inscription and correct it.
10.2.11 Duplicate Error Source
A setting is made for an error source to indicate which error will be the output of the
error source. No error source may be present more than once in a CM program.
► Check the setting under "Error messages" and correct it.
10.3 Error Messages for Operations/Conditions
10.3.1 Upper and Lower Measured Value Limits too Close to one another
For functions with upper and lower value limits, the two values must be at least 10
steps apart.
► Check the values that were entered and correct them.
10.3.2 Measured Value Limits Outside the Range of -30000 to 30000
For functions with upper and lower value limits, the entered values must be between -
30,000 and +30,000.
► Check the values that were entered and correct them.
10.3.3 Lower Measured Value Limit Greater than Upper Measurement
Value Limit
For functions with upper and lower measured value limits, the lower measured value
must be less than the upper measured value.
► Check the values that were entered and correct them.
10.4 Error Messages with Result Values/Actions
10.4.1 Invalid Output LED Selected
The selected LED does not exist in this device and must be set correctly.
► Check the LED setting and correct it.
10.4.2 Duplicate Use of Output LED
The selected LED is already being used in the current CM program and may not
appear twice.
► Check the LED selection and correct it.