HYDAC CSI-F-10 - Manual (Page 58)

GSM Radio Module CSI-F-10 Page 58
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
7.1.2 Display Device Information
• ere the values of the following status parameters are displayed:
- Part numer
- Serial number
- Channel information
The channel information reflects the numberical output values from the CM
program. Channel 0 corresponds to the first numerical output value in the CM
Program, Channel 1 the second, etc.
The upper and lower limits and the units stored in the CM program are
displayed.
If no CM Program is available in the device, then the connected sensors will be
displayed at this point with sub-channels, measurement ranges and units.
The upper and lower limits and the units stored in the sensor are displayed.