HYDAC CSI-F-10 - Manual (Page 23)

GSM Radio Module CSI-F-10 Page 23
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
PIN deactivation
If the PIN number is not input correctly or in full, during commissioning the SIM card
can be blocked.
We recommend therefore that the PIN of the SIM card is deactivated. To deactivate the
PIN code, place the SIM card in a mobile telephone and follow the device menu to
deactivate the PIN request.
Deactivating call forwarding / mailbox
Deactivate all the call forwards and the mailbox functions of the SIM card to be used to
achieve efficient accessibility with the CSI-F-10 GSM radio module.
6.2 Program enable
Program enable is effected via a micro-switch on the upper right edge of the board.
Providing the switch is set to ON you can configure the CSI-F-10, make settings,
transfer CM programs etc via a PC connection, irrespective of the permissions
specified in the settings (see Chapter 7.1.4).
• Remove the housing cover.
• Push the switch to the right to "ON" to switch on the program enable.
• Push the switch to the left to "OFF" to switch off the program enable.
Warning!
When the programming enable is switched off (switch set to 'OFF') no settings,
program changes or other changes to the device configuration can be made via a PC
connection.