Ip addressing, System tab, N o t e – ETC Unison Paradigm Touchscreen User Manual
Page 21
Touchscreen Setup Menu
19
IP Addressing
Two “IP Addressing” modes are available for use with the Touchscreen; Manual and
Automatic.
•
Manual Mode - in manual address mode the IP address and settings are user
configured. To change any portion of the address, simply touch inside the field you wish
to modify. A numeric keypad will display for edit of the selected field. Make the
modifications to the selected field then select another field for edit as necessary.
Pressing [Ok] saves your changes, exits the
and returns the display to
your default page (or inactivity page as defined in your configuration).
•
Automatic Mode - in automatic mode, the Touchscreen is configured to obtain an IP
address and other network settings automatically from a connected DCHP server. The
Touchscreen will display the current settings provided from the connected DHCP
server but the settings are not user editable. If no DHCP server is present, the
Touchscreen will assign itself a link-local address in the default 169.254.x.x range.
Pressing [Ok] saves your “Setup menu” changes, exits the
and returns the
display to your default page (or inactivity page as defined in your configuration),
automatic mode is not recommended for most applications.
System tab
The read only-information displayed on this tab is of interest only to ETC Technical Services
for troubleshooting and has minimal use to an end user.
•
System - the system information relates specifically to the Touchscreen hardware.
•
Board Revision - the Touchscreen hardware revision level.
•
Co-Processor - the co-processor provides portable specific functionality. These will
appear as "N/A" for wall mount Touchscreens.
•
Bootloader: the Touchscreen co-processor bootloader version.
N o t e :
When multiple Touchscreens are installed into your system, they must each have
a unique IP address. For example, 10.101.15.101, 10.101.15.102, etc. Duplicate
IP addresses will cause system communication problems.