Setup menu, About tab, N o t e – ETC Unison Paradigm Touchscreen User Manual
Page 10
8
Unison Paradigm Touchscreen User Manual
Setup Menu
Pressing the [Setup] button on the default page displays the
of the Touchscreen
setup menu. Alternatively, you can access the setup menu by pressing the “Mode” pin on
the Touchscreen I/O panel.
See “Touchscreen Inputs, Outputs and Indicators” on page 4.
Each tab of the setup menu displays a footer of buttons including [Service Pin], [Ok] and
[Cancel].
About tab
The About tab displays read-only information pertaining to the Touchscreen including;
•
MAC Address: a unique identifier assigned to the Touchscreen by ETC for
identification over the Paradigm network.
•
IP Address: the current network IP address assigned to the Touchscreen. This number
can be modified from the
.
•
Neuron Id: a station specific unique hardware address that is permanent to the
Touchscreen. This ID is used by the Paradigm Architectural Control Processor to bind/
associate (bind) stations within the LightDesigner configuration.
•
Bootloader: the bootloader software version.
•
Firmware: the firmware version loaded onto the Touchscreen. Firmware can be
updated, reference
for instructions.
•
Memory Usage: a Paradigm Touchscreen has 128 megabytes (Mb) of memory
available for configuration storage. The “Memory Usage” section displays the “Total”
memory available, the memory “Used” and the available memory that is “Free” for use.
•
Boot Reason: the last action that caused the Touchscreen to boot. Reasons for reboot
could be due to a [Reset] button press on the Touchscreen I/O panel, power loss, etc.
N o t e :
The firmware version in the Touchscreen must be compatible with the firmware
version in the Paradigm Architectural Control Processor (P-ACP) for the two
devices to communicate.