ElmoMC SimplIQ Command Reference - Manual (Page 52)

Error
Code
Error String / Description
Example / Remedy
111 KV[N] vector is invalid.
Invalid values in KV[N] parameters. Refer to the “Advanced Filter”
chapter in the
SimplIQ Software
Manual. If the vector was
configured by the Composer
auto-tuning wizard, email
Technical Support for assistance.
112 KV[N] defines scheduled block but
scheduling is off.
Invalid values in KV[N] parameters. See the syntax of KV[N]
parameters in the “Advanced
Filter” chapter of the
SimplIQ
Software Manual. If the vector was
configured by the Composer
auto-tuning wizard, email
Technical Support for assistance.
113 Exp task queue is full.
Internal error during auto-tuning process.
114 Exp task queue is empty.
Internal error during auto-tuning process.
115 Exp output queue is full.
Internal error during auto-tuning process.
116 Exp output queue is empty.
Internal error during auto-tuning process.
117 Bad KV setting for sensor filter.
Invalid setting for KV[76]…KV[87]. See KV command section of this
manual.
118 Bad KV vector This can happen when KV
parameters are not set according
to the correct feedback with
either length or value restriction.
119 Bad Analog sensor Filter When the filter KV, set for analog
feedback, is beyond its legal
range.
120 Bad number of blocks for Analog sensor
filter When the analog sensor filter
contains a wrong number of
blocks.
121 Analog sensor is not ready When the initiation procedure of
the Analog sensor was not
completed, and the motor is
being enabled.
SimplIQ Command Reference Manual Alphabetical Listing
MAN-SIMCR (Ver. 4.5)
3-39