Comelit RAS_SOLUTION - Manual (Page 27)

20
Figure 20 User Image Size
⑦ Select user device image from the Change User Image menu.
3.7.3 Sensor/Link design
① Click right mouse button on the back ground image.
② Select the Insert Sensor/Insert Link menu.
③ Select the device group > device > sensor or manual trigger item.
④ If you want to rename it, click right mouse button and select Rename.
⑤ If you want to the change image, click right mouse button and select Change Image.
⑥ If you want to use your own sensor/link image, click the Load Emap User Sensor Image button ( )/
Load Emap User Link Image ( ). And click right mouse button and select the Change User Image. The
user sensor and link images MUST be the same condition of width and height as above.
* Double-click the link, then the Emap changes to the selected link. You can make a layered Emap with
the link.
* The Manual Trigger is only available if the device supports it. Before designing the manual trigger,
please check the device specification and setup for that operation.
3.7.4 Emap controls
There are some Emap control buttons.
Table 7 Emap Control Buttons
Emap Control Buttons Operations
Wide 16:9 Split Mode (5,7,12,14,20,24,30)
Standard 4:3 Split Mode
(1,4,6,8,9,10,13,16,17,21,25,28,33,34,36,40,49,64)
Full Screen
Snapshot