COATS Series XR 1800 Balancer - Manual (Page 23)

Check-Spin - press to save 2 to 3 seconds of
time when a balancing wheel. This option elimi-
nates the runout measurement during the Check-
Spin.
Roundoff - toggle between 0.25-ounce or 0.01-
ounce weight increments.
Oper - (available in 3D view) used to cycle
through (recall) an operator’s memorized meas-
urements. This wheel balancer can be used simul-
taneously by four operators. See SPECIAL
FUNCTIONS on page 15 for further details.
OZ/g - (available in PROFILE view) toggle
between ounce or gram weight measurements.
Printer - (available in 3D view) prints a certificate
with important balancing information. See
PRINTER on page 9 for further details.
Profile or 3D - Toggle between a profile or 3D tire
image for weight placement.
Figure 30 - The Profile and 3D Icons
Dynamic Modes
Clip-on Weights - the initial screen. This mode is
used for most passenger and light truck tire assem-
blies using the most common location for corrective
weights. Clip-on weights are placed
on the inner and outer rim flanges.
Note: To reset the mode back to the initial screen at
any time, press the DYNAMIC option , or turn the
machine OFF then ON. Note that if an operator is in a
balance mode, it may be necessary to finish the bal-
ance cycle first.
Have the following items handy: steel rim passenger
or light truck tire wheel assembly mounted on the bal-
ancer and clip-on weights.
Figure 31 - Clip-on Weight Placement Screen
ALU modes - Select the MODE option for the
modes menu. All the ALU modes are dynamic balance.
Choose the option that best fits the available weight
locations.
- ALU-1
- ALU-2
- ALU-3
- ALU-4
Have the following items handy: an appropriate
wheel assembly mounted on the balancer and Tape-A-
Weights™. You must use the appropriate measure-
ment and weight placement technique for each plane
selection (page 7) to balance the wheel.
4
3
2
1
1
2
7
6
5
5
4
3
Important: Always read and follow the on-screen operating instructions. • 17
Video Balancer
Profile 3D