COATS Extended Balancer Stub Shaft - Manual

8113188 01 03/02 © COPYRIGHT 2001 ALL RIGHTS RESERVED PRINTED IN U.S.A.
Extended Balancer Stub Shaft
For use with COATS 950, 1025, 1050, & 1055 Model Series Balancer
Installation
1. Turn off and unplug the Balancer.
2. Prevent the faceplate from rotating and use an appropriate size
wrench to remove the existing stub-shaft. (Fig. 1)
3. Using a penetrating oil, carefully clean the pilot hole in the end of
the motor shaft. (Fig. 2)
4. Remove the 1.125 inch diameter 7.50 inch shaft from it’s protective
sleeve.
5. Make sure the pilot diameter is free of any debris.
6. Carefully install the shaft onto the motor shaft using an appropriate
size wrench and tighten to 40 to 60 ft-lbs. (Fig. 3)
Figure 1 - Remove Existing Stub Shaft
Figure 3 - Install the New Extended Stub Shaft Figure 2 - Clean the Motor Shaft