COATS Kit 8113893 Lateral Run Out Service User Manual
COATS Equipment
8113894 01 06/04
© COPYRIGHT 2004 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
Lateral Runout Service
Kit 8113893
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
Parts Identification
Ref
Qty.
Description
1
1
Lateral Runout Assembly
(with Cable and Sonar)
2
1
Lateral Runout Guard
*
2
1/4-20 x 1-1/4" HHCS
*
2
1/4-20 Hex Nylok Nut
3
1
Lateral Runout Decal
4
1
11/16 Rubber Grommet
*
1
1/4-20 x 1" Self Tap Screw
5
1
Danger Laser Decal
6
1
Laser Conformance Decal
7
1
Laser Aperture Decal
*Not Shown
Instructions
1. Unplug connector 12 at power PCB.
2. Remove angle bracket and connector from flange
of sandplate inside front of cabinet.
3. Remove screws and nuts holding lateral runout
mounting rail and guard to cabinet and remove lateral
runout assembly from machine.
4. Install new Lateral Runout Assembly and Guard on
cabinet at same location as the old one and fasten with
1/4-20 x 1-1/4" HHCS and 1/4-20 Hex Nylok Nuts.
5. Mount angle bracket with connector on the inside
of cabinet in the same position as before.
6. Connect one end of the audio cable to this con-
nector and the other end to connector 12 at power PCB.
Angle
Bracket &
Connector
Lateral Runout
Cable Entering
Cabinet
1
1
2
Runout Guard
Lateral Runout
Assembly
Screw
Location
Screw
Location
3
6
4
7
5