COATS Series XR 1800 Balancer - Manual (Page 15)

Important: Always read and follow the on-screen operating instructions. • 9
Printer
Use the printer, on especially equipped models,
(shown in figure 14) to provide a BALANCER CERTIFI-
CATE for the wheel balance service.
Figure 14 - Printer
Important: The soft-
ware will not recognize
the printer unless there
is paper in the printer.
This is also the case if
the paper is threaded
between the paper roller
and the printer top cover.
The flashing LED on front of printer indicates power
to the printer, but the printer could still be incorrectly
connected or out of paper.
Important: To activate the printer function, press the
button, select the GENERAL SET-UP option
select the PRINTER option , and set the PRINTER
option to ON.
Also, toggle ON or OFF the following printer options
for the printout (default is ON for all these options):
Option OWNER ADDRESS - prints the owner’s
address (see page 15 to customize to the machine).
Option SPIN NO. - records the spin no. from
CYCLE HISTORY (see page 16 for more information).
Option OPERATOR NO. - indicates the operator
number and name (see page 17 to customize to the
machine).
Option VEHICLE TAG NO. - provides a space for
the operator to write in the vehicle tag number.
Option LOC. ON VEHICLE - operator uses this
diagram to manually check the wheel location that was
serviced.
Option CORRECTED - operator uses this area to
manually check either YES if runout was corrected or
N.R. if not required.
On selected screens, to print the BALANCER CER-
TIFICATE press option . Note that the printout
option CORRECTED is only available for RUNOUT
DIAGNOSTIC (see MATCHING on page 20 for more
information).
Figure 15 - Completed Printer Balancer Certificate
7
6
7
6
5
4
3
2
1
5
MENU 5
Video Balancer
Printer
Install Roll of
Thermal Paper