COATS Hood Installation Sheet - Manual

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
Hood Installation Instructions
1. Install nylon bearings in the ends of the hood pivot
tube.
2. Insert hood tube thru the hood pivot bearings.
3. Install flat washer and retainer washer on the end
of the hood bar making certain that the retainer washer
is fully seated.
4. Install plastic protector over the end of the hood
tube.
5. Hook hood spring on bottom of cabinet adjacent to
the rear chassis leg. Hold hood in upright position and
install spring on to the hood cam stud.
Note: Place the caliper hook on the hood assembly
by removing one of the hex head screws on the right
side of the hood and hood bar and replace the hex head
screw with the caliper hook attached. The caliper hook
can also be attached to the unit by utilizing one of the
weight tray hex head screws is the same manner.
8111543 01 07/10 © COPYRIGHT 2005 ALL RIGHTS RESERVED PRINTED IN U.S.A.
Hood Installation
Instructions
Washer
Retainer
Washer
Plastic
Protector
Hood Bar
Hood Cam
Stud (1250)
Nyliner Bearing
Hood Cam
Stud (6450)
Nyliner Bearing