COATS Kit 8113883 Printer Bracket Serive - Manual

8113882 00 05/04 © COPYRIGHT 2004 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
P Prriin ntte err B Brra ac ck ke ett
S Se errv viic ce e K Kiitt 8 81 11 13 38 88 83 3
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
Parts Identification
Ref. Qty. Description
1 1 Rubber Grommet
2 2 Hex Washer Head Screw
3 1 Printer Bracket
4 1 Loop Fabric *Velcro ® Strip
5 1 Printer Instructions Decal
6 1 Caterpillar Grommet
7 2 Nylon Cable Tie
Instructions
1. Lift printer and unplug RJ11 connector on bottom
of printer. Set printer aside for reuse.
2. Untie wiring at back of bracket.
3. Remove two screws holding bracket to side of
monitor tower. Discard old bracket. Install new round
Rubber Grommet on monitor tower, if required.
4. Install new Printer Bracket to monitor tower using
two self-tapping Hex Washer Head Screws in the same
holes used by the old bracket.
5. Install black Caterpillar Grommet in oval shaped
hole at back of Printer Bracket and tie printer cable
through hole as before.
6. Apply adhesive-backed *Velcro ® Strip abut 1-inch
from left edge of Printer Bracket and 1 to 1/2-inch from
front of bracket.
7. Insert RJ11 connector in bottom of printer and
place printer on Velcro as before.
8. Apply Printer Instruction Decal centered on front of
bracket.
1
2
3
4
5
7 6
RJ11 Connector Plug
Printer Instruction
Decal Location
* Velcro ® is a registered trademark of Velcro Industries B.V.