CHAMPION UL-130 Manual - Manual (Page 44)

34
Initial Start-Up - Model UL130
Pump Priming - Detergent, Rinse-aid and Sanitizer Dispensing Pumps - UL130
UL130 Control Panel
! VERY IMPORTANT !
The chemical dispensing pumps must be primed before operating the dishwasher.
Priming the Dispensing Pumps
PRIME OFF/DRAIN
ON
POWER START
SANI
RINSE
160
140
120
10 0
80
60
20
170 180
190
200
21 0
220
70 80
95
90
100
105 C F
60
50
40
20
0 NSF
TE
M
P
ER
A
TU
RE
1. Make sure the chemical containers are full and the correct pick-up tubes are in the
containers.
2. Turn the dishwasher power switch ON. The switch will illuminate and the dishwasher
will fill with water.
3. The Prime push button primes the Sanitizer
pump and the Rinse-aid pump.
4. Open the dishwasher door. Push and hold
the prime push button UP to the SANI
position until sanitizer is observed entering
the wash tank compartment.
5. Release the PRIME push button.
6. Push and hold the Prime push button
DOWN to the RINSE position until rinse-aid
is observed entering the wash tank
compartment.
7. Release the Prime push button.
8. Close the door.
! ATTENTION !
The detergent pump does not have a prime push button. Run four
empty cycles checking the detergent pick-up tubing to make sure that
air bubbles are moving through the pick-up tubing indicating that the
detergent is dispensing.
PRIME
SANI
RINSE