CHAMPION UL-130 Manual - Manual (Page 39)

29
Water Connections - UL130
1. All models have a 6 ft. flexible hot water fill hose with a 3/4" female garden hose
connector.
2. A 1/2" or larger main incoming supply line should be installed to the dishwasher.
3. A 1/2" or larger shut-off valve should be installed in the main water supply as close to the
dishwasher as possible for service.
4. The UL130 has a built-in flow control which requires that the incoming hot water supply
pressure must be between 25-95 psi.
5. The hot water supply must provide a minimum of 120°F/49°C, measured at the
dishwasher; however, 140°F/60°C is recommended.
6. A water hardness of 3 grains/gal (US) [51.3 mg/L] or less is recommended.
NOTE
Plumbing connections must comply with national, provincial local plumbing and sanitary codes.
! IMPORTANT !
Make sure that the flexible water supply and drain hoses are not kinked.
1. All models have a 6 ft.. 5/8" I.D. drain hose. The maximum drain height connection
must not exceed 3 ft.[0.9 m].
2. A 3/4" hose barb fitting is
strapped to the drain hose to
connect the drain hose to a
wye drain fitting.
.
The service part number for the
hose barb is P/N 0512321.
Model UL130 - Installation
Drain Connections -
UL130