CHAMPION UL-130 Manual - Manual (Page 22)

12
1. The detergent and rinse-aid pumps are located on a center bracket behind the lower-front
access panel.
2. Each pump is equipped with 6 feet [1.8 m] of supply tubing, stiffener tubes, and strainers.
3. A red label marked DETERGENT and a blue label marked RINSE-AID identify the chemical
lines.
4. For UH230B and UH230, the detergent enters the wash tank compartment through a fitting
at the right rear of the wash compartment and he rinse-aid enters the final rinse piping
through a fitting located on the upper-left rear side of the dishwasher near the vacuum breaker.
5. For UH130B and UH130, the detergent and rinse-aid enter the wash tank compartment
through a fitting on the right-hand side for the wash compartment.
Initial Start-up - Model UH130, UH130B, UH230, UH230B
Pumps and Injection Points - Detergent and Rinse-aid Dispensing Pumps
Models UH130, UH130B and UH230, UH230B only
DETERGENT RINSE-AID
CHEMICAL
PICK-UP
TUBES
The chemical dispensing pumps are located on
the center bracket behind the lower front panel
of the dishwasher.
The chemical dispensing pick-up tubes are stowed at
the rear of the dishwasher.
! ATTENTION !
Contact a chemical supplier for detergent and rinse-aid chemicals.
The supplier can adjust the chemical dispensing pumps too.
! VERY IMPORTANT !
ALWAYS USE A COMMERCIAL-GRADE NON-CHLORINATED DETERGENT.
PLACE THE CHEMICAL SUPPLY CONTAINERS AS CLOSE TO THE MACHINE AS POSSIBLE.
DO NOT ELEVATE THE CHEMICAL CONTAINERS ABOVE THE FINISHED FLOOR.